That was an oversight on my part in the sample but I still couldn’t get it to work. After I fooled around with it, I realized that I needed to put the layer that displays the number above the Mask and the Dynamic Property that controls it below the Mask. I’m used to putting Dynamic Properties at the top so I hadn’t tried that trait order before. It’s working now.
I did notice a strange glitch while I was fooling with this, though. At one point, I changed the standard CTRL M for the Mask command to a keyword. Then later, I changed the keyword back to CTRL M and it wouldn’t work. I had to remove the Mask trait and start a new one before I could get a key command to work again.
Thus spake DrNostromo:
I did notice a strange glitch while I was fooling with this, though. At
one point, I changed the standard CTRL M for the Mask command to a
keyword. Then later, I changed the keyword back to CTRL M and it
wouldn’t work. I had to remove the Mask trait and start a new one before
I could get a key command would work again.
Is this reproducible?
–
J.
Thus spake DrNostromo:
I did notice a strange glitch while I was fooling with this, though. At
one point, I changed the standard CTRL M for the Mask command to a
keyword. Then later, I changed the keyword back to CTRL M and it
wouldn’t work. I had to remove the Mask trait and start a new one before
I could get a key command would work again.
Is this reproducible with svn8080?
–
J.
I have no problem changing a Mask command now so that seems to be ok.