Layer looping

Hi.

I’m trying to get an image to go through 4 different states.
It a a small PNG with the number “1” in it and I want it to change to “2”, then “3”, and then “4”.
No need for it to be able to go back to a lower number.

Still, when I try to to do, the image change from “1” to “2”, then back to “1”…

I’ve added the layer trait the 3 PNG files I needed (“2” “3” and “4”). Yet it won’t loop through… :blush:

What am I doing wrong ?

Rgds,

BC

Is it possible that you are only toggling the active layer and not actually
incrementing it?

It sounds like you have the 1 in the base image and the 2, 3, & 4 in the
layer. If that’s the case, and you merely toggle the active state of the
layer trait, it will only alternate between 1 & 2. What you should do is
have all four in the same layer trait and have it always active.

  • M.

On 10 September 2010 15:49, bREw oneiro@myself.com wrote:

Hi.

I’m trying to get an image to go through 4 different states.
It a a small PNG with the number “1” in it and I want it to change to
“2”, then “3”, and then “4”.
No need for it to be able to go back to a lower number.

Still, when I try to to do, the image change from “1” to “2”, then back
to “1”…

I’ve added the layer trait the 3 PNG files I needed (“2” “3” and “4”).
Yet it won’t loop through… :oops:
What am I doing wrong ?

Rgds,

BC

Is it possible that you are only toggling the active layer and not actually incrementing it?

It sounds like you have the 1 in the base image and the 2, 3, & 4 in the layer.� If that’s the case, and you merely toggle the active state of the layer trait, it will only alternate between 1 & 2.� What you should do is have all four in the same layer trait and have it always active.


- M.

On 10 September 2010 15:49, bREw <oneiro@myself.com> wrote:

Hi.



I’m trying to get an image to go through 4 different states.

It a a small PNG with the number “1” in it and I want it to change to

“2”, then “3”, and then “4”.

No need for it to be able to go back to a lower number.



Still, when I try to to do, the image change from “1” to “2”, then back

to “1”…



I’ve added the layer trait the 3 PNG files I needed (“2” “3” and “4”).

Yet it won’t loop through… �:oops:

What am I doing wrong ?



Rgds,



BC