I’ve set up a main map where the ‘mark pieces that move’ setting is set to Always, but the ‘Mark Unmoved’ button icon is set to null. Instead of using the default button, a separate GKC is used to reset Moved pieces to Unmoved. (it’s combined with a GKC to also reset Firing status, into a single Reset multi-action button.)
This was working correctly in the module in 3.0–there was no ‘Mark Unmoved’ icon showing.
However, the default ‘Mark Unmoved’ icon is showing up in the same module in 3.1 even when the actual icon image is set to null in the map properties.
Is it possible to post your module somewhere so we can take a look?
2009/3/14 mycenae <messages@forums.vassalengine.org (messages@forums.vassalengine.org )>
I’ve set up a main map where the ‘mark pieces that move’ setting is set to Always, but the ‘Mark Unmoved’ button icon is set to null. Instead of using the default button, a separate GKC is used to reset Moved pieces to Unmoved. (it’s combined with a GKC to also reset Firing status, into a single Reset multi-action button.)
This was working correctly in the module in 3.0–there was no ‘Mark Unmoved’ icon showing.
However, the default ‘Mark Unmoved’ icon is showing up in the same module in 3.1 even when the actual icon image is set to null in the map properties.
Post generated using Mail2Forum (mail2forum.com )
Have reproduced the problem. Working on it.
Brent.
*********** REPLY SEPARATOR ***********
On 14/03/2009 at 12:13 AM mycenae wrote:
I’ve set up a main map where the ‘mark pieces that move’ setting is set
This was working correctly in the module in 3.0–there was no ‘Mark
However, the default ‘Mark Unmoved’ icon is showing up in the same module
Messages mailing listMessages@forums.vassalengine.org forums.vassalengine.org/mailman/ … engine.org
Post generated using Mail2Forum (mail2forum.com )
Fixed in swampwallaby-3.1@5303
Bug [2687178] Mark unmoved button appears even if icon set to null
B.
*********** REPLY SEPARATOR ***********
On 14/03/2009 at 12:13 AM mycenae wrote:
I’ve set up a main map where the ‘mark pieces that move’ setting is set
This was working correctly in the module in 3.0–there was no ‘Mark
However, the default ‘Mark Unmoved’ icon is showing up in the same module
Messages mailing listMessages@forums.vassalengine.org forums.vassalengine.org/mailman/ … engine.org
Post generated using Mail2Forum (mail2forum.com )
Thus spake “Brent Easton”:
Merged to 3.1@5304, trunk@5305.
–
Messages mailing listMessages@forums.vassalengine.org forums.vassalengine.org/mailman/ … engine.org
Post generated using Mail2Forum (mail2forum.com )