PME in STL

Using 3.1.17

In STL when using the destination option “Another counter, selected by properties” and in the PME specifying BasicName = $BasicName$ && CurrentMap = SomeOtherMap…doesn’t work. Piece will go to the right map but it goes and stacks on a piece that has a different BasicName altogether. Grid snapping is not the issue (i.e none exists)

However if I specify exact coords where it should go instead (x,y) of using a PME in STL all is fine. Cannot check on 3.1.16 at moment

Hi Tim,
Tried hard to reproduce this in both 3.1.17 and 3.2 without success. Can you provide a demo module?
Thanks,
Brent.

Bug 4106 - Send to Location to a counter using a Property Expression not working

Fixed merged into Brent-3.2@7988.

Also needed in 3.0.18.

Thus spake Brent Easton:

Bug 4106 - Send to Location to a counter using a Property Expression not
working

Fixed merged into Brent-3.2@7988.

Also needed in 3.0.18.

Merged to 3.1@8000, trunk@8001.


J.