TeTeT
January 22, 2008, 11:13pm
1
I try to convert the Downtown module from 2.9 to 3.0. Unfortunately when saving the module from the Vassal 3 editor an empty buildfile is created.
Here’s the process:
Open module in 2.9
Remove custom Activator code
Remove turn tracker
Save from 2.9
Open module in 3.0
Save module in 3.0
I’ll update the Downtown module later to the modules section.
Thus spake “TeTeT”:
I try to convert the Downtown module from 2.9 to 3.0. Unfortunately when savi
ng the module from the Vassal 3 editor an empty buildfile is created.
Here’s the process:
Open module in 2.9
Remove custom Activator code
Remove turn tracker
Save from 2.9
Open module in 3.0
Save module in 3.0
I’ll update the Downtown module later to the modules section.
Which version of the Downtown module are you trying to update?
–
J.
Messages mailing list
Messages@forums.vassalengine.org
forums.vassalengine.org/mailman/ … engine.org
Post generated using Mail2Forum (mail2forum.com )
TeTeT
January 23, 2008, 1:04am
3
There are a lot of things in this module. Could you give me a hint as to
where I should look for the custom Activator code?
TeTeT
January 26, 2008, 10:12pm
5
I removed it from the module to make the update work.
Thus spake “TeTeT”:
When I open the module in the 2.9.9 editor, the image for every single
piece shows as “nil”. This is likely part of the problem. Is it this
way for you?
I think I’m going to need a copy of the module from before you removed
any of the custom code.
–
J.
Messages mailing list
Messages@forums.vassalengine.org
forums.vassalengine.org/mailman/ … engine.org
Post generated using Mail2Forum (mail2forum.com )