Bottom Card of Deck

[masterdinadan]

Is there any way at all to draw the bottom card of a deck without having to reverse it? I was thinking there may be some way to do it with a Global Key Command, but then I don’t think there is any way to check a card’s position as part of the condition.

If I could perform a DOWN keystroke on all of the cards in the deck except for the last one, it would be moved to the top, which is just fine, but I’m not sure that this is possible either. Is there a property that returns the number of cards in a deck?

[Brent_Easton]

*********** REPLY SEPARATOR ***********

On 27/01/2010 at 6:03 PM masterdinadan wrote:

Is there any way at all to draw the bottom card of a deck without having
to reverse it? I was thinking there may be some way to do it with a
Global Key Command, but then I don’t think there is any way to check a
card’s position as part of the condition.

If I could perform a DOWN keystroke on all of the cards in the deck except
for the last one, it would be moved to the top, which is just fine, but
I’m not sure that this is possible either. Is there a property that
returns the number of cards in a deck?

Not in 3.1. It is included in 3.2 - $DeckPosition$

For now, you are stuck with reversing the Deck, drawing the card, then Reversing the Deck again.

B.

---

Messages mailing list
Messages@forums.vassalengine.org
forums.vassalengine.org/mailman/ … engine.org

Post generated using Mail2Forum (mail2forum.com)